Repair Procedures: Removal

Remove the rear wheel and tire (A) from rear hub.
Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

CAUTION: Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

Fig 1: Removing Rear Wheel And Tire From Rear Hub
Courtesy of HYUNDAI MOTOR AMERICA
Support the rear lower arm (A) with a jack as shown in the illustration below.
NOTE: Certainly install Jack as being danger because of the tension.

Fig 2: Supporting Rear Lower Arm With Jack
Courtesy of HYUNDAI MOTOR AMERICA
Remove the spring (A), the upper pad (B) and the lower pad (C).
Tightening torque:

137.3 ~ 156.9 N.m (14.0 ~ 16.0 kgf.m, 101.3 ~ 115.7 lb-ft)

Fig 3: Removing Spring, Upper Pad And Lower Pad
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
Check the rear alignment.
(Refer to Rear Suspension System - "Rear Alignment ")