DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Conditions for setting DTC	Possible Cause
DTC Strategy		Checking the completion of the motor position sensor calibration	Not completed resolver calibration Abnormal Calibration value Calibration failure
Enable Conditions		IG key "ON" Aux. Battery voltage is between 9V and 16V
Threshold Value		Calibration is not completed
Information Code	601	Excessive decision of the calibration result value during the calibration
	602	Engine idling keeping failure during the calibration
	603	Other failure of GCU occurs during the calibration
	604	Excessive deviation of the middle result value during the calibration
	605	Not "P" range during the calibration
	606	Clutch open during the calibration
	607	Not engine idling during the calibration Excess of the idling stabilization time during the calibration
	608	Not HEV Ready during the calibration
	609	Not sufficient cooperation control condition (in 10sec) during the calibration
	610	SOC before the calibration is under 15%
	611	Resolver calibration has not been completed at the initial production process
	622	Resolver calibration has not been completed after replacing a known-good HPCU
Diagnostic Time		Immediately
MIL		2 Driving Cycle
Service Lamp		ON

NOTE: HSG Position Sensor*: "HYBRID STARTER & GENERATOR MOTOR_Resolver"