Current data Analysis
WARNING: This page is about a different variant/trim than selected.
- IG key "ON"/Ready, Transmission Shift Lever "P" range.
- Select "Current Data" with GDS.
- Operate the vehicle within DTC Enable conditions in General information.
- Monitor "Generator (HSG) Resolver Mal Counter" parameter.
Reference Data
GENERATOR (HSG) RESOLVER MAL COUNTER REFERENCENormal □ Generator (HSG) Resolver Mal Counter: 1~399times Abnormal □ Generator (HSG) Resolver Mal Counter: 400times - Is the displayed current data normal?
YES
- Fault is intermittent caused by Poor Contact in HSG Position Sensor* connector or GCU (HPCU)*'s connector or was repaired and GCU (HPCU)* memory was not cleared.
→ Repair or replace as necessary, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "WIRING INSPECTION " procedure.
- Fault is intermittent caused by Poor Contact in HSG Position Sensor* connector or GCU (HPCU)*'s connector or was repaired and GCU (HPCU)* memory was not cleared.
NOTE:
HSG Position Sensor*: "HYBRID STARTER & GENERATOR MOTOR_Resolver"
GCU (HPCU)*: "HYBRID POWER CONTROL UNIT_HPCU"
GCU (HPCU)*: "HYBRID POWER CONTROL UNIT_HPCU"