Current data Analysis

WARNING: This page is about a different variant/trim than selected.

IG key "ON"/Ready, Transmission Shift Lever "P" range.
Select "Current Data" with GDS.
Operate the vehicle within DTC Enable conditions in General information.
Monitor "Generator (HSG) Temperature" parameter.
Reference Data
GENERATOR (HSG) TEMPERATURE REFERENCE

Normal □ Generator (HSG) Temperature: -20°C~185°C
Is the displayed current data normal?
YES
- Fault is intermittent caused by Poor Contact in Generator (HSG) Temperature Sensor*'s connector or GCU (HPCU)*'s connector, or GCU (HPCU)* memory was not cleared after repair.
- Go to "WIRING INSPECTION " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.

NOTE: HSG Temperature Sensor*: "HYBRID STARTER & GENERATOR MOTOR_Motor TEMP. Sensor"
GCU (HPCU)*: "HYBRID POWER CONTROL UNIT_HPCU"