LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Elantra Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - 1.4L) >> Intake Air Temperature Sensor (IATS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the manifold absolute pressure sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor from the surge tank.
Fig 1: Locating Manifold Absolute Pressure Sensor Connector And Installation Bolt
G12020571Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals