Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the air cleaner assembly.
(Refer to "AIR CLEANER ")
Disconnect the neutral position switch connector (A).

Fig 1: Disconnecting Neutral Position Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the neutral position switch.

Fig 2: Removing Neutral Position Switch
Courtesy of HYUNDAI MOTOR AMERICA
Replace a new one and install the neutral position switch, then connect the connector.
Tightening torque:

39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)