Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect scantool and select "Diagnostic Trouble Codes (DTCs)" mode.
2. Clear DTC using a scantool.
3. Drive the vehicle within DTC Enable conditions in General information. (Refer to "General Information ").
4. After selecting "Diagnostic Trouble Codes (DTCs)" mode and check DTC is recorded again.
5. Are any DTCs recorded?

   YES 

   • Go to the applicable troubleshooting procedure.

   NO 

   • System is performing to specification at this time.