PODS-F Zeroing Procedure

You should perform PODS-F reset procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly)

1. Ignition "OFF", connect GDS.
2. Ignition "ON" & Engine "OFF", select Airbag system and "PODS-F Reset" mode.
   Fig 1: Scantool Display - ID Register

   Courtesy of HYUNDAI MOTOR AMERICA
3. The GDS will show the two PODS-F Zeroing function steps.
   1. Erase PODS-F diagnostic codes.
   2. PODS-F initialization.
   Fig 2: Scantool Display - PODS-F Reset

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: This step must be done PODS-F reset, when the front passenger seat is empty.
4. Select product configuration.
   1. No Heater Seat configuration: (C1)
   2. Heater Seat Configuration: (C2)
   3. Vent & Heater Seat Configuration: (C3)
      Fig 3: Scantool Display - Product Configuration

      Courtesy of HYUNDAI MOTOR AMERICA
      CAUTION: Before the starting the PODS-F zeroing process, cross check seat correct configuration with actual vehicle.
      If you see the center console, you can find different buttons per each different seat configuration type. (Refer to the below Fig 4)

      1. No Heater Seat Configuration: (C1)
         Fig 4: No Heater Seat Configuration

         Courtesy of HYUNDAI MOTOR AMERICA
      2. Heater Seat Configuration: (C2)
         Fig 5: Heater Seat Configuration

         Courtesy of HYUNDAI MOTOR AMERICA
      3. Vent & Heater Seat Configuration: (C3)

      Fig 6: Vent & Heater Seat Configuration

      Courtesy of HYUNDAI MOTOR AMERICA
5. The PODS-F initialization procedure will be performed.
   Fig 7: Scantool Display - PODS-F Reset

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 8: Scantool Display - Test Completed

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: Erase the SRSCM diagnostic codes after completing the PODS-F zeroing.
   NOTE: In case of zeroing failure

   • Code 01: Requestor ID out of range.
   • Code 02: ODS ECU faults.
   • Code 03: ODS sensor short to ground.
   • Code 04: Open between ODS ECU and mat.
   • Code 05: ODS ECU has not been trimmed.
   • Code 06: Configuration disabled in ECU calibration.
   • Code 07: Configuration value out of range. (Calibratable)
   • Code 08: Used in zero Request response only.
   • Code 09: Algo enabled this ignition cycles.
   • Code 10: QX Frequency not stable.
   • Code 0A: Upper offset value created during the zero process.
   • Code 0B: Lower offset value created during the zero process.
   • Code 0C: Voltage diagnostic
   • Code 0D: The delta of QX_Freq_Low and QX_Freq_High must remain low.
   • Code 0E: Temperature is above O deg C during the zero process.
   • Code 0F: Re-read QX Final compare delta limit. (Zero verify)