Repair Procedures: Replacement

CAUTION:

Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.

Remove the Front Driveshaft.
(Refer to Driveshaft Assembly - "Front Driveshaft ")
Remove the circlip (B) from the driveshaft spline (A).

Fig 1: Removing Circlip From Driveshaft Spline
Courtesy of HYUNDAI MOTOR AMERICA
Remove both boot bands from the TJ case.

Fig 2: Removing Both Boot Bands From TJ Case (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Removing Both Boot Bands From TJ Case (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the TJ case (A).

Fig 4: Removing TJ Case
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.
Fig 5: Locating Alignment Marks On Spider Roller Assembly, Joint Case And Shaft Spline
Courtesy of HYUNDAI MOTOR AMERICA
Remove the snap ring (A) from the shaft.

Fig 6: Removing Snap Ring From Shaft
Courtesy of HYUNDAI MOTOR AMERICA
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).

Fig 7: Removing Spider Assembly From Driveshaft
Courtesy of HYUNDAI MOTOR AMERICA
Clean the spider assembly.
Remove the TJ boot (A).
CAUTION:
- For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).

Fig 8: Removing TJ Boot

Courtesy of HYUNDAI MOTOR AMERICA