Repair Procedures: Replacement

CAUTION:

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Remove the front seat shield inner cover.
(Refer to Front Seat - "Front Seat Shield Inner Cover ")
Remove the front seat shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover ")
Remove the protector (A).

Fig 1: Locating Protector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 2: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Push the protecter (A), and then front seat cushion cover (C) from the front seat frame (B).

Fig 3: Locating Protecter, Front Seat Cushion Cover And Front Seat Frame
Courtesy of HYUNDAI MOTOR AMERICA
Remove the front seat cushion cover (A) from the front seat frame.

Fig 4: Locating Front Seat Cushion Cover
Courtesy of HYUNDAI MOTOR AMERICA
After removing the velcro tape (A) and hog-ring clips (B) on the front of seat cushion and remove the front seat cushion cover (C).

Fig 5: Locating Velcro Tape, Hog-Ring Clips And Front Seat Cushion Cover
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
- Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).
Fig 6: Replacing Hog-Ring Clips Using Special Tool (09880-4F000)
Courtesy of HYUNDAI MOTOR AMERICA