Repair Procedures: Installation

Install the wiper motor.
Install the crank arm.
Torque:

12.7~17.6 Nm (1.3~1.8 kgf.m, 9.4~13.0 lbf.ft)

CAUTION: To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
Install the lower and upper linkage to the wiper motor crank arm.
Install the wiper motor and linkage assembly and then connect the wiper motor connector.
Torque:

7~11 Nm (0.7~1.1 kgf.m, 5.0~7.9 lbf.ft)
Install the cowl top cover.
Install the windshield wiper arm and blade.
Torque:

23 ~ 27 Nm (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lbf.ft)
NOTE:
- - The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
  If necessary, adjust the wiper arm and blade.
Install the wiper arm and blade to the specified position.
A: Auto stop position (Blade)

Fig 1: Installing Wiper Arm And Blade
Courtesy of HYUNDAI MOTOR AMERICA

Set the cowl top cover on the specified spray position.

NOTE:

- When you turn on the washer, confirm 50% or more of washer fluid lands within the spray area.
- If the spray area is not within the standard positions, adjust the nozzle(s).

Fig 2: Adjusting Nozzle

Courtesy of HYUNDAI MOTOR AMERICA