Removal And Installation
- Disconnect the battery negative terminal first, then the positive terminal.
Tightening Torque
(-) terminal:
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
(+) terminal:
7.8 ~ 9.8N.m (0.8 ~ 1.0kgf.m, 5.8 ~ 7.2lb-ft)
- Loosen the mounting bolts (A, B)
- Turn the adjusting bolt(B) clockwise in loose tension.
- Remove the drive belt (A).
- Disconnect the air compressor connector(A) and the alternator connector (B), and remove the cable (C) from alternator "B" terminal.
- Remove the alternator(A).
Tightening torque
12mm (0.47in) bolt:
19.6 ~ 26.5 Nm (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)
14mm (0.55in) bolt:
29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 lb-ft)
- Installation is the reverse order of removal.
- Adjust the alternator belt tension after installation.