LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2017 >> Accent SE, 4D Hatchback, Automatic Trans >> Repair and Diagnosis >> Drivelines & Axles >> Axle Shafts >> Driveshaft Assembly >> Front Driveshaft >> Repair Procedures >> Reassembly

Repair Procedures: Reassembly

  1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots.
  2. Apply grease to the joint boot on the side of the wheel and install the boot.
  3. Install the clamp.
    G12017835Courtesy of HYUNDAI MOTOR AMERICA
  4. Assemble the transaxle side joint boot and bands.
  5. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
    G12017836Courtesy of HYUNDAI MOTOR AMERICA
    G12017837Courtesy of HYUNDAI MOTOR AMERICA
  6. Add specified grease to the joint boot as much as it was wiped away at inspection.
  7. Install the both boot band.
  8. To control the air in the TJ boot, keep the specified distance between the boot bands when they are tightened.
    ENGINE GREASE SPECIFICATIONS

    Engine TM Distance (L) mm (in.)
    LH RH
    Gasoline 1.6 GDI AT 488.9 (19.24) 780.7 (30.74)
    MT 512.1 (20.16) 792.5 (31.20)
  9. Using the SST (09495-3K000), secure the TJ boot band.
    G12017838Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals