Repair Procedures: Disassembly

CAUTION:

Do not disassemble the BJ assembly.
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
The boot band should be replaced with a new one.

Remove the circlip (B) from the driveshaft spline (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove both boot bands from the transaxle side joint(TJ) case.

Courtesy of HYUNDAI MOTOR AMERICA
Pull out the boot from transaxle side joint case (B).
While dividing joint(TJ) boot (A) of the transaxle side, wipe the grease in TJ case (B) and collect them respectively.

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the snap ring (A) and spider roller assembly (B) from the shaft.

Courtesy of HYUNDAI MOTOR AMERICA
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).

Courtesy of HYUNDAI MOTOR AMERICA
Clean the spider assembly.

Remove the boot (A) of the transaxle side joint(TJ).

CAUTION: For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).

Courtesy of HYUNDAI MOTOR AMERICA

Using a plier or flat-tipped (-) screwdriver, remove the both side of clamp (B) of the dynamic damper (A).

Courtesy of HYUNDAI MOTOR AMERICA
Fix the driveshaft (A) with a vice (B) as illustrated.

Courtesy of HYUNDAI MOTOR AMERICA
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
Saperate the dynamic damper (A) from the shaft (B) carefully.

Courtesy of HYUNDAI MOTOR AMERICA