Repair Procedures: Removal

[Bank 1/Sensor 1] 

1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
2. Disconnect the Connector (A), and then remove the Sensor (B).
   NOTE: Note that the SST (Part No.: 09392-1Y100) is useful when removing the Heated Oxygen Sensor.
   Fig 1: Identifying Special Tool (Part No. 09392-1Y100)

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 2: Heated Oxygen Sensor Connector (Bank 1/Sensor 1)

   Courtesy of HYUNDAI MOTOR AMERICA
   Fig 3: Heated Oxygen Sensor (Bank 1/Sensor 1)

   Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Sensor 2] 

1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
2. Remove the Console Side Cover (A).
   Fig 4: Console Side Cover (Bank 1/Sensor 2)

   Courtesy of HYUNDAI MOTOR AMERICA
3. Disconnect the Connector (A).
   Fig 5: Heated Oxygen Sensor Connector (Bank 1/Sensor 2)

   Courtesy of HYUNDAI MOTOR AMERICA
4. Remove Heated Oxygen Sensor (A).

Fig 6: Heated Oxygen Sensor (Bank 1/Sensor 2)

Courtesy of HYUNDAI MOTOR AMERICA