LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Turbo R-Spec, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System - 1.6L GDI) >> Crankshaft Position Sensor (CKPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Crankshaft Position Sensor Connector (A) and remove the Sensor (B) after removing the Installation Bolt.
    Fig 1: Crankshaft Position Sensor Connector And Installation Bolt
    G10607933Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals