Repair Procedures: Installation

Remove the Ignition Key from the vehicle.
Disconnect the Battery Negative Cable from Battery and wait for at least three minutes before beginning work.
Place a Passenger Airbag on the Crash Pad and tighten the Passenger Airbag Mounting Bolts.
Tightening Torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

Fig 1: Passenger Airbag Crash Pad Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Install the Crash Pad.
(Refer to: Body procedure - "CRASH PAD ").
Tighten the Passenger Airbag Mounting Bolts.
Tightening Torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Connect the Passenger Airbag Harness Connector to the SRS Main Harness Connector.
Reinstall the Glove Box Housing.
(Refer to: Body procedure - "CRASH PAD ").
Reconnect the Battery Negative Cable.
After installing the Passenger Airbag (PAB), confirm proper system operation:
1. Turn the Ignition Switch ON; the SRS Indicator Light should be turned on for about six seconds and then go OFF.