LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Disc Brake System) >> Brake Pedal >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pre-Tighten the Bracket Fixing Bolt (A) in the Dash Panel.
    Fig 1: Bracket Fixing Bolt
    G10605093Courtesy of HYUNDAI MOTOR AMERICA
  2. Install the Brake Booster and Brake Pedal Member Fixing Nuts (A) securely.

    Tightening Torque: 

    18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

    Fig 2: Brake Booster And Brake Pedal Member Fixing Nuts
    G10605094Courtesy of HYUNDAI MOTOR AMERICA
  3. Tighten the Bolt (A) securely in the Dash Panel.

    Tightening Torque: 

    18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

    Fig 3: Dash Panel Bolt
    G10605095Courtesy of HYUNDAI MOTOR AMERICA
  4. Install the Snap Pin (A) and Clevis Pin (B).
    Fig 4: Snap Pin And Clevis Pin
    G10605096Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • Before installing the Pin, apply the Grease to the Clevis Pin.
    • Use a new Snap Pin whenever installing.
  5. Install the Stop Lamp Switch securely.
  6. Connect the Stop Lamp Switch Connector (A).
    Fig 5: Stop Lamp Switch Connector
    G10605097Courtesy of HYUNDAI MOTOR AMERICA
  7. Adjust the Brake Pedal Height and Free Play.
  8. Check the Brake Pedal Operation after installing the Brake Pedal.
  9. Install the Crash Pad Lower Panel.
  10. Reconnect the Negative (-) Battery Cable.
scientia non olet · About LEMON Manuals