LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Base, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - 1.6L GDI >> Fuel Tank >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Release the Residual Pressure in Fuel Line (Refer to: "RELEASE RESIDUAL PRESSURE IN FUEL LINE " in this procedure).
  2. Remove the Rear Seat [LH] (Refer to: "Seat" in BD procedure).
  3. Remove the Fuel Pump Service Cover (A).
    Fig 1: Fuel Pump Service Cover
    G10608001Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the Fuel Pump Connector (A).
  5. Disconnect the Fuel Feed Tube Quick Connector (B).
  6. Disconnect the Fuel Tank Pressure Sensor Connector (C).
  7. Disconnect the Vapor Tube (D).
    Fig 2: Fuel Pump Connector, Feed Tube Quick Connector, Fuel Tank Pressure Sensor Connector And Vapor Tube
    G10608002Courtesy of HYUNDAI MOTOR AMERICA
  8. Lift the vehicle and support the Fuel Tank with a jack.
  9. Remove the Center Muffler Assembly (Refer to: "Intake And Exhaust System" in EM procedure).
  10. Disconnect the Fuel Filler Hose (A).
    Fig 3: Fuel Filler Hose
    G10608003Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the Under Cover (A) and the Parking Brake Line Installation Bolt (B).
    Fig 4: Under Cover And Parking Brake Line Installation Bolt
    G10608004Courtesy of HYUNDAI MOTOR AMERICA
  12. Remove the Fuel Tank from the vehicle after removing the Fuel Tank Band (A).
Fig 5: Fuel Tank Band
G10608005Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals