LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Timing System - 1.6L T-GDI) >> Drive Belt >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the Drive Belt (A).
    Fig 1: Engine Drive Belt Routing Diagram
    G10604087Courtesy of HYUNDAI MOTOR AMERICA
  2. Adjust Tension by tightening the Alternator Tension Adjust Bolt (B) and then install the Mounting Bolts (A).

    Tightening Torque 

    12mm (0.47in) Bolt:

    19.6 ~ 26.5 Nm (2.0 ~ 2.7 kgf.m, 14.5 ~ 19.5 lb-ft)

    14mm (0.55in) Bolt:

    29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 lb-ft)

    Fig 2: Alternator Tension Adjust Bolt And Mounting Bolts
    G10604088Courtesy of HYUNDAI MOTOR AMERICA
  3. Connect the Battery Negative Terminal.
scientia non olet · About LEMON Manuals