Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-Terminal (A) on the Magnet Switch Assembly.

Fig 1: M-Terminal
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the 2 Screws (A), detach the Magnet Switch Assembly (B).

Fig 2: Magnet Switch Assembly And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the Brush Holder Mounting Screw (A) and the Trough Bolts (B).

Fig 3: Brush Holder Mounting Screw And Trough Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Rear Bracket (A) and Brush Holder Assembly (B).

Fig 4: Rear Bracket And Brush Holder Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Yoke (A).

Fig 5: Yoke Removal
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Packing (A), Lever Plate (B), Lever (C), Armature (D).

Fig 6: Packing, Lever Plate, Lever And Armature
Courtesy of HYUNDAI MOTOR AMERICA
Press the Stopper (A) using a Socket (B).

Fig 7: Pressing Stopper Using Socket
Courtesy of HYUNDAI MOTOR AMERICA
After removing the Stop Ring (A) using Stopper Pliers (B).

Fig 8: Removing Stop Ring Using Stopper Pliers
Courtesy of HYUNDAI MOTOR AMERICA
Remove the stop Ring (B), Stopper (A), Overrunning Clutch (C) and Armature (D).

Fig 9: Stop Ring, Stopper, Overrunning Clutch And Armature
Courtesy of HYUNDAI MOTOR AMERICA

Information
- Using a suitable Pulling Tool (A), pull the Overrunning Clutch Stopper (C) over the Stop Ring (B).
Fig 10: Pulling Overrunning Clutch Stopper Over Stop Ring Using Suitable Pulling Tool
Courtesy of HYUNDAI MOTOR AMERICA