LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Veloster Base, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Starting System - 1.6L T-GDI) >> Starter Relay >> Repair Procedures >> Inspection

Repair Procedures: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the Battery Negative Terminal.
  2. Remove the Fuse Box Cover.
  3. Remove the Starter Relay (A).
    Fig 1: Starter Relay Location
    G10604438Courtesy of HYUNDAI MOTOR AMERICA
  4. Using an Ohmmeter, check that there is Continuity between each Terminal.
    Terminal Continuity
    30 - 87 NO
    85 - 86 YES
  5. Apply 12V to Terminal 85 and Ground to Terminal 86.

    Check for continuity between Terminals 30 and 87.

    Fig 2: Checking For Continuity Between Terminals 30 And 87
    G10604439Courtesy of HYUNDAI MOTOR AMERICA
  6. If there is no Continuity, replace the Starter Relay.
  7. Install the Starter Relay.
  8. Install the Fuse Box Cover.
scientia non olet · About LEMON Manuals