Repair Procedures: Removal

Remove the valve body assembly. (Refer to Valve body System - "VALVE BODY ")
Disconnect the input & output speed sensor connector (A).
Loosen the main connector bolt (B).
Tightening Torque :

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 1: Locating Main Connector Bolt
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the solenoid valve connector (A).
1. Press the lock
2. Pull up lever
Fig 2: Disconnecting Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector mounting clip (A).

Fig 3: Locating Solenoid Valve Connector Mounting Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve connector (A) by pushing down from the transaxle.

Fig 4: Removing Solenoid Valve Connector By Pushing Down From Transaxle
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Replace the O-Ring (A) before reinstalling solenoid valve connector.
  
  Fig 5: Locating O-Ring And Solenoid Valve Connector
  Courtesy of HYUNDAI MOTOR AMERICA