LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Tucson SE, 4WD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Control System - 2.0L >> Shift Cable >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Air cleaner assembly and air duct. (Refer to Engine Mechanical System - "AIR CLEAN 2.0L ")
  2. Battery and battery tray. (Refer to Engine Electrical System - "BATTERY ")
  3. Remove the nut (A) from the manual control lever.
  4. Remove the shift cable (B) from the bracket (C) at transaxle side.
    Fig 1: Removing Nut From Manual Control Lever
    G11644021Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the floor console assembly. (Refer to Body - "FLOOR CONSOLE ")
  6. Remove the snap pin (A).
    Fig 2: Removing Snap Pin
    G11644022Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the air duct (A).
    Fig 3: Removing Air Duct
    G11644023Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the shift cable.
    1. Disconnect the cable bracket (B) from the shift lever after pushing the lock.
    2. Disconnect the cable holder (A) from the shift lever.
      Fig 4: Disconnecting Cable Holder From Shift Lever
      G11644024Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the airbag module. (Refer to Restraint - "AIRBAG MODULE ")
  10. Disconnect the shift cable retainer (B) after removing the nuts.
  11. Remove the shift cable by pulling it toward the interior.
    Fig 5: Disconnecting Shift Cable Retainer And Nuts
    G11644025Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals