LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Tucson SE, 4WD >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Control System - 2.0L >> Inhibitor Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Make sure vehicle does not roll before setting shift lever to "N" position.
  2. Disconnect the negative (-) battery cable.
  3. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - "Air cleaner")
  4. Remove the battery and battery tray. (Refer to Engine Electrical System - "BATTERY ")
  5. Disconnect the inhibitor switch connector (A).
  6. Remove the shift cable mounting nut (B).
    Fig 1: Removing Shift Cable Mounting Nut
    G11643993Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the manual control lever (B) and the washer after removing a nut (A).
    Fig 2: Removing Manual Control Lever And Washer Nut
    G11643994Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the inhibitor switch (A) after removing the bolts (2ea).
    Fig 3: Removing Inhibitor Switch Bolts
    G11643995Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals