Repair Procedures: Removal

Pull the knob (A) in the direction of "F" and remove the knob.

Fig 1: Pulling Knob
Courtesy of HYUNDAI MOTOR AMERICA
Remove the floor console assembly. (Refer to Body - "FLOOR CONSOLE ")
Remove the air duct (A).

Fig 2: Removing Air Duct
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A) from the shift lever.

Fig 3: Disconnecting Connector From Shift Lever
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the fixing clip (A) of wiring.

Fig 4: Disconnecting Fixing Clip Of Wiring
Courtesy of HYUNDAI MOTOR AMERICA
Remove the snap pin (A).

Fig 5: Removing Snap Pin
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the control cable.
1. Disconnect the cable holder (A) from the shift lever.
2. Disconnect the cable bracket (B) from the shift lever after pushing the lock.
  
  Fig 6: Disconnecting Cable Bracket From Shift Lever
  Courtesy of HYUNDAI MOTOR AMERICA
Remove the bolts and then shift lever assembly (A).
Tightening Torque :

8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Fig 7: Removing Bolts And Shift Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the P position switch mounting bracket (A).

Fig 8: Removing P Position Switch Mounting Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the P position switch (A) and shift lock solenoid (B).
Disconnect the main connector (C) from the shift lever.

Fig 9: Disconnecting Main Connector From Shift Lever
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the manual mode switch housing (A).

Fig 10: Disconnecting Manual Mode Switch Housing
Courtesy of HYUNDAI MOTOR AMERICA
P position switch, shift lock solenoid, manual mode switch housing, main connector assembly (A).

Fig 11: Locating Shift Lock Solenoid, Manual Mode Switch Housing And Main Connector Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Remove the mounting bracket (A) of terminals from the main connector.

Fig 12: Removing Mounting Bracket Of Terminals From Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove each terminals (F) of the P position switch (A), shift lock solenoid (B), manual mode switch housing (C) after released lock (E) from the main connector (D).
CAUTION:
- Record the location of the wiring colors before disconnecting the terminals.
  
  Fig 13: Main Connector Wiring Colors Location
  Courtesy of HYUNDAI MOTOR AMERICA
  
  Fig 14: Removing Each Terminals Of P Position Switch, Shift Lock Solenoid, Manual Mode Switch Housing
  Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Connector information
  
  Fig 15: P Position Switch Connector Terminals
  Courtesy of HYUNDAI MOTOR AMERICA