LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Tucson SE, 4WD >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Ignition Switch >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Proceed to: Body - "CRASH PAD LOWER PANEL ")

  3. Remove the steering column upper and lower shroud panel.

    (Proceed to: Body - "STEERING COLUMN SHROUD PANEL ")

  4. Remove the multifunction switch.

    (Proceed to: Body Electrical System - "Multifunction Switch")

  5. Remove the key warning/immobilizer connector (A).
    Fig 1: Locating Key Warning/Immobilizer Connector
    G11670500Courtesy of HYUNDAI MOTOR AMERICA
  6. Insert key and turn it to ACC position.
  7. Pushing lock pin (A) with the Awl.
    Fig 2: Pushing Lock Pin With Awl
    G11670501Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the key lock cylinder (A).

    B: Key warning switch

    C: Ignition switch connector

    Fig 3: Removing Key Lock Cylinder
    G11670502Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the ignition switch connector (A).
    Fig 4: Locating Ignition Switch Connector
    G11670503Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the ignition switch (A) after loosening the mounting bolts.
Fig 5: Locating Ignition Switch Mounting Bolts
G11670504Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals