LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Tucson Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System - 2.0L) >> Accelerator Position Sensor (APS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.
Fig 1: Locating Accelerator Pedal Module Installation Bolt And Nuts
G11643675Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals