LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Sonata Limited >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.4L (Except HEV) >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
    Fig 1: Camshaft Position Sensor Connector And Installation Bolt
    G10573489Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Exhaust] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the hanger and the protector.
  4. Remove the installation bolt (B), and then remove the sensor.
    Fig 2: Camshaft Position Sensor Connector And Installation Bolt
    G10573490Courtesy of HYUNDAI MOTOR AMERICA
NOTE: When installing the sensor connector be sure to keep the wiring clip position (A).
Fig 3: Locating Wiring Clip Position
G10573491Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals