LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Sonata Limited 2.0T >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 2.0L (Except HEV) >> Injector >> Repair Procedures >> Installation

Repair Procedures: Installation

Fig 1: Identifying Injector Components
G10573392Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • DO NOT reuse the used injector fixing clip.
CAUTION:
  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
CAUTION:
  • Apply Engine oil to the injector O-Ring.
  • DO NOT reuse the used injector O-Ring.
CAUTION:
  • DO NOT reuse the used bolt.
CAUTION:
  • When inserting the injector, be careful not to damage the injector tip.
CAUTION:
  • DO NOT reuse the support disc.
  • DO NOT reuse the injector rubber washer.
  • When replacing the rubber washer, the steel plate (A) part should face the cylinder head and the rubber plate (B) part should face the injector body part.
Fig 2: Identifying Injector Steel And Rubber Plates
G10573393Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
  • DO NOT reuse the combustion seal.
CAUTION:
  • When tightening the delivery pipe installation bolts, tighten them in accordance with the order ((2) (3) (1) (4)) after hand tightening.
Fig 3: Delivery Pipe Installation Bolts Tightening Sequence
G10573394Courtesy of HYUNDAI MOTOR AMERICA
  1. Installation is reverse of removal.
scientia non olet · About LEMON Manuals