LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Sonata Hybrid >> Repair and Diagnosis >> Transmission >> Transmission Control Systems >> Automatic Transaxle Control System (HEV) >> Transaxle Oil Temperature Sensor >> Repair Procedures >> Removal

Repair Procedures: Removal

  1. Remove the air cleaner assembly and air duct. (Refer to "AIR CLEANER ")
  2. Remove the Hybrid Power Control Unit (HPCU) assembly.

    (Refer to Hybrid Control System - "HPCU ")

  3. Remove the under cover. (Refer to "ENGINE ROOM UNDER COVER ")
  4. Remove the valve body assembly. (Refer to "VALVE BODY ")
  5. Disconnect the input/output speed sensor connector (A).
  6. Remove the solenoid valve connector assembly after removing bolts (B).
    Fig 1: Locating Input/Output Speed Sensor Connector And Bolts
    G12061063Courtesy of HYUNDAI MOTOR AMERICA
  7. Disconnect the main connector (A).
    1. Press the lock
    2. Raise the lever
    Fig 2: Pressing Main Connector Lock
    G12061064Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the clip (A) after removing the bolt.
    Fig 3: Locating Clip
    G12061065Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the main connector (A) from the transaxle.
    Fig 4: Disconnecting Main Connector From Transaxle
    G12061066Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • Replace the O-Ring (A) before reinstalling the main connector.
    Fig 5: Locating O-Ring
    G12061067Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals