Repair Procedures: Installation

Install the shift cable retainer (A).
Tightening torque:

9.8 - 14.7 N.m (1.0 -1.5 kgf.m, 7.2 - 10.8 lb-ft)

Fig 1: Locating Shift Cable Retainer
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (A) in the shifter lever.
NOTE:
- Install the cable after placing the shift lever and the manual control lever in the N position.
Fig 2: Installing Shift Cable In Shifter Lever
Courtesy of HYUNDAI MOTOR AMERICA
Install the shift cable (B) in the cable bracket (C).
Align the hole (E) in the manual control lever with the "N" position hole (F) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No: 09480-A3800).
Lightly tighten the nut (A) after connected the shift cable (B) in the manual control lever (D).
Push shift cable (B) lightly to "F" direction shown below to eliminate free play of shift cable.
Tighten the nut (A) to the specified torque.
Tightening torque:

9.8 - 14.7 N.m (1.0 -1.5 kgf.m, 7.2 - 10.8 lb-ft)

Fig 3: Inserting Inhibitor Switch Guide Pin (SST No:09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Install the airbag module.
(Refer to "AIRBAG MODULE ")
Install the air duct (A).

Fig 4: Locating Air Duct
Courtesy of HYUNDAI MOTOR AMERICA
Install the floor console assembly.
(Refer to "FLOOR CONSOLE ")
Install the air cleaner assembly.
(Refer to "AIR CLEANER ")
Install the battery and battery tray.
(Refer to "AUXILIARY 12V BATTERY ")
Install the air duct.
(Refer to "AIR CLEANER ")
CAUTION:
- Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.