Repair Procedures: Removal

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Lift the vehicle.
Disconnect the EWGA connector (A).

Fig 1: Identifying EWGA Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the exhaust manifold heat protector.
(Refer to: Engine Mechanical System - "EXHAUST MANIFOLD ").
Remove the shaft link assembly (B) after removing the C-Ring (A).

Fig 2: Identifying Shaft Link Assembly And C-Ring
Courtesy of HYUNDAI MOTOR AMERICA
Remove the turbo charger water pipe installation bolt (A).
Remove the EWGA after removing the bolts (B).

Fig 3: Identifying Turbo Charger Water Pipe Installation Bolt

Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When carrying the turbo charger, do not hold the rod of the turbo charge to prevent bending the rod.