Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Hyundai Sonata. However, it is still accessible from the selected car via links, so may be relevant.

Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

Fig 1: Positioning Stop Lamp Switch
Courtesy of HYUNDAI MOTOR AMERICA
After inserting, turn the stop lamp switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.

Fig 2: Turning Stop Lamp Switch Clockwise
Courtesy of HYUNDAI MOTOR AMERICA
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance : 1.0 ~ 2.0 mm (0.04~ 0.08 in.)

Fig 3: Checking Gap Between Stop Lamp Switch And Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Connect the stop lamp switch connector.
NOTE: If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0 mm (0.04~ 0.08 in), perform the above process again.
Install the lower crash pad.
(Refer to "CRASH PAD ")