Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

WARNING:

DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake]

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the camshaft position sensor connector (A).
Remove the installation bolt (B), and then remove the sensor.

Fig 1: Identifying Camshaft Position Sensor Connector (Bank 1/Intake)
Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Exhaust]

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the heater protect cover.
Disconnect the camshaft position sensor connector (A).
Remove the hanger and the protector.
Remove the installation bolt, and then remove the sensor.

Fig 2: Identifying Camshaft Position Sensor Connector (Bank 1/Exhaust)
Courtesy of HYUNDAI MOTOR AMERICA