LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Santa Fe SE, FWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System >> Fuel Line >> Repair procedures >> Removal

Repair procedures: Removal

  1. Turn the ignition switch OFF, and then remove battery (-) cable.
  2. Release the residual pressure in fuel line.

    (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  3. Disconnect the low pressure fuel quick-connector (A).
    Fig 1: Low Pressure Fuel Quick-Connector
    G10575004Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the vapor hose (A) which is connected from the PCSV.
    Fig 2: Vapor Hose
    G10575005Courtesy of HYUNDAI MOTOR AMERICA
  5. Lift the vehicle.
  6. Remove the fuel tank.

    (Refer to "FUEL TANK ")

  7. Disconnect the vapor tube quick-connector (A).
    Fig 3: Vapor Tube Quick-Connector
    G10575006Courtesy of HYUNDAI MOTOR AMERICA
  8. Open the vapor tube and low fuel line fixing clip to using driver.
  9. Release the under cover (A) after remove the mounting bolts.
    Fig 4: Under Cover
    G10575007Courtesy of HYUNDAI MOTOR AMERICA
  10. Disconnect the fuel & brake line protect (A) from the fixing clip.
    Fig 5: Fuel And Brake Line Protector
    G10575008Courtesy of HYUNDAI MOTOR AMERICA
  11. Disconnect the fuel line fixing bracket (A) to engine room low.
    Fig 6: Fuel Line Fixing Bracket
    G10575009Courtesy of HYUNDAI MOTOR AMERICA
  12. Remove the fuel line.
scientia non olet · About LEMON Manuals