Repair procedures: Removal

CAUTION:

NOTE:

Remove the roof side molding.
(Refer to "ROOF SIDE MOLDING ")
Remove the rear package tray trim.
(Refer to "REAR PACKAGE TRAY TRIM ")
Remove the rear curtain.
(Refer to "REAR CURTAIN ")
Spread WD-40 on the outer edges of rear window glass.
Cut out the adhesive using the cutter (A).
Information
- Use the cutter with a 20 to 30 cm-long blade.
Fig 1: Cutting Out Adhesive Using Cutter
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on the edge (B) while pulling the piano wire (A) to the left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 2: Pulling Piano Wire To Left And Right
Courtesy of HYUNDAI MOTOR AMERICA
Put in a piano wire (A) through the corner of the windshield glass and insert wire grips into both ends of the wire.

Fig 3: Putting Piano Wire Through Corner Of Windshield Glass
Courtesy of HYUNDAI MOTOR AMERICA
Cut off the sealant on (A-A), (B-B), (C-C), while pulling a piano wire (A) to the left and right.
CAUTION:
- Put on gloves to protect your hands.
- Heat may occur when working on the wires. Be careful not to burn your hands.
- Be careful not to disconnect the piano wire.
Fig 4: Pulling Piano Wire To Left And Right
Courtesy of HYUNDAI MOTOR AMERICA
Carefully remove the rear window glass (A).
NOTE:
- When removing and installing the rear window glass, an assistant is necessary.

Fig 5: Rear Window Glass

Courtesy of HYUNDAI MOTOR AMERICA