LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Equus Signature >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Air Suspension System >> Compressor >> Repair procedures >> Removal

Repair procedures: Removal

NOTE:
  • This system combines a sensor and electronic parts with mechanical components, so be careful not to subject the system to strong impacts.
  • If any pins are visible inside the electric signaling connector, do not expose it to water.
  • A plug protects the air inlet of the reservoir tank from dust or other particles. Do not remove the plug except when assembling or disassembling the reservoir tank.
  • DO NOT hold any parts by their electric wires while moving them, as the weight of the part may damage the wire or connection during transport.
  • Do not pile components on top of each other.
  • Do not apply power to operate the compressor directly (may cause malfunctions/overheating).
  • Be careful not to break any circuits by twisting or bending the cables.
  • DO NOT drop any parts.
  • Check the color of each air hose before connecting it. After connecting a hose, pull it to ensure that the connection holds firm.
  • The air connection section of the air hose includes a dust cover to prevent the introduction of foreign substances. DO NOT remove this cap for any process besides connecting the hose.
  • When installing an air hose, be careful not to kink the hose.
  • DO NOT reuse the air hose connector connected to an air hose assembly after it has been disassembled.
  • The markings on both ends of the air hose distinguishes the assembly, so be careful not to peel it off.
  1. Removal the front bumper.

    (Refer to "FRONT BUMPER ")

  2. Removal the left head amp.

    (Refer to "HEAD LAMP LEVELING DEVICE ")

  3. Removal the EHPS motor.

    (Refer to "POWER STEERING MOTOR ")

  4. Disconnect the connector (A) & air hose (B).
    Fig 1: Disconnecting Connector & Air Hose
    G10383184Courtesy of HYUNDAI MOTOR AMERICA
    IMPORTANT:
    • Work with time until air is discharged.
    • Separate with push the air tube connected to center portion.
  5. Remove the bracket bolt.
    Fig 2: Removing Bracket Bolts (1 Of 2)
    G10383185Courtesy of HYUNDAI MOTOR AMERICA
    Fig 3: Removing Bracket Bolts (2 Of 2)
    G10383186Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the solenoid valve (A) from the compressor by loosening the bolt.
    Fig 4: Disconnecting Solenoid Valve From Compressor
    G10383187Courtesy of HYUNDAI MOTOR AMERICA
  7. Installation is the reverse of removal.
    NOTE:
    • Take care not to drop.
    • Confirm the tube color in installation process.
    • Confirm that whether the tube is escaped a not by puling it.
    • Be careful not to disconnection of cable by its twist or excessive bending.
    • Do not remove cap except assemble.
    • Take care not to twisted.
    • If disassemble the air tube connector, do not reuse it.
    • Air tube marking takes care not to be came off.
scientia non olet · About LEMON Manuals