Repair procedures: Inspection: Notes

Disconnect the negative (-) battery terminal.
Remove the shield outer cover.
(Refer to "FRONT SEAT SHIELD OUTER COVER ")

Fig 1: Shield Outer Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the power seat air lumber support switch connector (A).

Fig 2: Power Seat Air Lumber Support Switch Connector Terminals
Courtesy of HYUNDAI MOTOR AMERICA

With the power seat air lumber support switch in each position, make sure that continuity exists between the terminal below. If continuity is not as specified, replace the switch.

Fig 3: Power Seat Air Lumber Support Switch Connector Terminals Continuity Chart

Courtesy of HYUNDAI MOTOR AMERICA

Position & Switch Name		Inflate Cell	Deflate Cell
1	Upper	Upper & middle	Lower
2	Middle	Upper & middle & lower	-
3	Lower	Middle & lower	Upper
4	Deflate	-	Upper & middle & lower