LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2016 >> Elantra Sport, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Ignition Switch Assembly >> Repair procedures >> Removal

Repair procedures: Removal

  1. Disconnect the negative (-) battery terminal.
  2. Remove the driver crash pad lower panel.

    (Refer to "CRASH PAD ")

  3. Remove the steering column upper and lower shrouds.

    (Refer to "CRASH PAD ")

  4. Remove the wiper switch.

    (Refer to Procedures found in "MULTIFUNCTION SWITCH ")

  5. Remove the ignition switch after disconnecting the ignition switch 6P connector.
  6. Remove the key warning/immobilizer connector (A).
    Fig 1: Key Warning/Immobilizer Connector And Key Warning/Illumination Switch
    G10531271Courtesy of HYUNDAI MOTOR AMERICA
  7. After loosening the screw, remove the key warning switch and key Illumination (B).
  8. Pushing lock pin with key ACC.
  9. Remove the key lock cylinder (A).
    Fig 2: Key Lock Cylinder
    G10531272Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals