Repair procedures: Replacement

Remove the front seat track mounting cover.
After loosening the seat assembly mounting bolts, remove the front seat assembly (A).
Tightening torque:

49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2~47.0 lb-ft)

Fig 1: Front Seat Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the seat buckle connector (A), seat warmer connector (B), SAB connector (C), PODS connector (D).
[Driver's]

Fig 2: Seat Buckle Connector, Seat Warmer Connector, SAB Connector, PODS Connector (Driver)
Courtesy of HYUNDAI MOTOR AMERICA

[Passenger's]

Fig 3: Seat Buckle Connector, Seat Warmer Connector, SAB Connector, PODS Connector (Passenger)
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- SEAT MOUNTING BOLT INSTALLATION PROCEDURE
- Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
- Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
- Set the seat into the most rearward position. Check the front mounting bolt completely.
- Check that the seat operates to and fro smoothy and the locking portion locks properly.