Repair Procedures: Disassembly

Remove the Rear Cover (A) after removing Nuts.

Fig 1: Rear Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Mounting Bolts (A) and the Brush Holder Assembly (B).

Fig 2: Brush Holder Assembly With Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the Slip Ring Guide (A) after pulling it.

Fig 3: Removing Slip Ring Guide
Courtesy of HYUNDAI MOTOR AMERICA
Remove the OAD (Overrunning Alternator Decoupler) Cap.
NOTE:
- When installing, replace with new OAD Cap.
Remove the OAD (Overrunning Alternator Decoupler) Pulley (A) using the Special Tool.

Fig 4: Removing Overrunning Alternator Decoupler Pulley Using Special Tool
Courtesy of HYUNDAI MOTOR AMERICA
Unsolder the 3 Stator Leads (A).

Fig 5: Identifying Stator Leads
Courtesy of HYUNDAI MOTOR AMERICA
Remove the 4 through Bolts (A).

Fig 6: Removing Through Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the Rotor (A) and Bracket (B).

Fig 7: Identifying Rotor And Bracket

Courtesy of HYUNDAI MOTOR AMERICA