Heater control unit Replacement

CAUTION:

When prying with a flat-up screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the floor console tray (A).

Fig 1: Identifying Floor Console Tray
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console bezel (A).

Fig 2: Identifying Console Bezel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (B).

Fig 3: Identifying Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the crash pad center panel (A).

Fig 4: Identifying Crash Pad Center Panel
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the hazard lamp switch assembly (A).

Fig 5: Identifying Hazard Lamp Switch Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (B).

Fig 6: Identifying Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the heater control unit (A).

Fig 7: Loosening Heater Control Unit Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (B).

Fig 8: Identifying Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order the removal.
NOTE:
- Make sure the connectors are plug-in in properly.