Repair procedures: Removal

Disconnect the negative (-) battery terminal.
Remove the steering column upper and lower shrouds.
(Refer to "STEERING COLUMN AND SHAFT ")
Remove the ignition switch (A) after disconnecting the 6P connector (B).

Fig 1: Removing Ignition Switch 6P Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the key warning and immobilizer connector (A).

Fig 2: Removing Key Warning And Immobilizer Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the key illumination lens (A).

Fig 3: Removing Key Illumination Lens
Courtesy of HYUNDAI MOTOR AMERICA
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder after pushing lock pin (B) with key ACC.

Fig 4: Removing Key Lock Cylinder

Courtesy of HYUNDAI MOTOR AMERICA