LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Genesis Coupe 3.8 Ultimate, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Brake System) >> Stop Signal Electronic Module >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2016 Hyundai Genesis and 2015 Hyundai Genesis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the AVN unit.

    (Refer to "AVN SYSTEM ")

    (Refer to "PREMIUM AVN SYSTEM ")

  3. Remove the glove box.

    (Refer to "GLOVE BOX ")

  4. Disconnect the stop signal electronic module connector (A).
  5. Remove the clip (B) and then remove the stop signal electronic module.
    Fig 1: Stop Signal Electronic Module Connector And Clip
    G10453353Courtesy of HYUNDAI MOTOR AMERICA
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals