Repair procedures: Removal

Remove the battery and the battery tray.
(Refer to "CHARGING SYSTEM ")
Remove the under cover (A).
Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 1: Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the air cleaner assembly and air duct.
(Refer to Procedures found in "ENGINE AND TRANSAXLE ASSEMBLY ")
Remove the battery and battery tray.
(Refer to "BATTERY ")
Remove the under cover.
(Refer to Procedures found in "ENGINE AND TRANSAXLE ASSEMBLY ")
Remove the drain plug (A) and reinstall the drain plug after draining ATF totally.
Drain plug tightening torque:

34.3 ~ 44.1 N.m (3.5 ~ 4.5 kgf.m, 25.3 ~ 32.5 lb-ft)

Fig 2: Drain Plug
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: Replace the gasket before reinstalling the drain plug.
Disconnect the air breather hose (A) from the valve body cover after disconnecting the clamp (B).

Fig 3: Air Breather Hose And Clamp
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bolts (B).
Remove the valve body cover (A).
Tightening torque:

11.8 ~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)

Fig 4: Valve Body Cover And Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the bolts.
Disconnect the solenoid valve connector (B) and the oil temperature sensor (A) from the valve body.
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 5: Disconnecting Solenoid Valve Connector And Oil Temperature Sensor From Valve Body
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve support bracket (B) and the valve body mounting bolt (A-1ea).
Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 6: Solenoid Valve Support Bracket
Courtesy of HYUNDAI MOTOR AMERICA
Remove the torque converter control solenoid valve (A).

Fig 7: Torque Converter Control Solenoid Valve
Courtesy of HYUNDAI MOTOR AMERICA