Repair Procedures: Removal

Remove the battery and the battery tray.
(Refer to: "CHARGING SYSTEM " in EE procedure).
Remove the under cover (A).
Tightening Torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft))

Fig 1: Locating Under Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the air cleaner assembly and air duct.
(Refer to: Engine Mechanical System - "AIR CLEANER ").
Remove the battery and battery tray.
(Refer to: Engine Electrical System - "BATTERY ").
Remove the under cover.
(Refer to: Engine Mechanical System - "ENGINE ROOM UNDER COVER ").
Remove the valve body.
(Refer to: Hydraulic System - "VALVE BODY ").
Disconnect the solenoid valve connector (A).

Fig 2: Disconnecting Solenoid Valve Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve main connector mounting clip (A) after removing the bolt.

Fig 3: Locating Solenoid Valve Main Connector Mounting Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve main connector (A).

Fig 4: Locating Solenoid Valve Main Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the input & output speed sensor connector (A) after press the lock from the solenoid valve main wiring.

Fig 5: Locating Input And Output Speed Sensor Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the solenoid valve main wiring & oil temperature sensor after loosening the main connector bolts (A).

Fig 6: Locating Solenoid Valve Main Connector Bolts
Courtesy of HYUNDAI MOTOR AMERICA