LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Veloster Turbo, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - Non-Turbo) >> Knock Sensor (KS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2013 Hyundai Veloster and 2012 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake manifold (Refer to "Intake And Exhaust System ").
  3. Disconnect the injector connector (A).
  4. Remove the installation bolt (B), and then remove the sensor from the cylinder block.
    Fig 1: Identifying Injector Connector And Installation Bolt
    G08807041Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals