Component Inspection

ESP (ESC) switch Check
1. IG "OFF".
2. Disconnect the ESP (ESC) switch connector.
3. Measure resistance between power terminal and siganl terminal of the ESP (ESC) switch connector.
  Specification:
  
  Approx. below 1Ω - (In case of pressing the ESP (ESC) switch)
  
  Approx. ∞ Ω - (In case of not pressing the ESP (ESC) switch)
4. Is the measured resistance within specifications?
  YES
  - Fault is intermittent caused by poor connection in ESP (ESC) switch harness and/or HECU's connector. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  NO
  - Substitute with a known-good ESP (ESC) switch and check for proper operation. If problem is corrected, replace ESP (ESC) switch and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.