LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2014 >> Genesis Coupe 3.8 Ultimate, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis - 3.8L (1 Of 3) >> DTC P0153: O2 Sensor Circuit Slow Response (Bank 2/Sensor 1) >> Scantool Diagnostics >> Monitor GDS Data

Monitor GDS Data

  1. Connect GDS to Data Link Connector (DLC).
  2. Ignition "ON".
  3. Select "DTC" button, and then Press "DTC Status" to check DTC's information from the DTCs menu.
  4. Read "DTC Status" parameter.
    Fig 1: Scantool Display - DTC Status Parameter
    G00520227Courtesy of HYUNDAI MOTOR CO.
  5. Is parameter displayed "Present fault"?

    YES 

    NO 

    • Clear DTC, and check if this DTC is set after test-driving vehicle under the "Enable Conditions" shown in DTC DETECTING CONDITION CHART. If DTC isn't displayed after the test, it was intermittent fault. Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals